| 电路板钻孔用盖板性能要求 |
| 添加时间：2019/12/23 16:31:11 浏览次数： |
| 1、硬度要求。一定的表面硬度防止钻孔上表面毛刺,但太硬会磨损钻头； 1. Hardness requirements. A certain surface hardness can prevent burr on the upper surface of drilling, but too hard will wear the bit; 2、本身成分不含树脂,否则钻孔时将腻污孔; 2. The component itself does not contain resin, otherwise it will be greasy when drilling; 3、要求导热系数大,能迅速将钻孔时产生的热量带走,降低钻头的温度; 3. High thermal conductivity is required, which can quickly take away the heat generated during drilling and reduce the temperature of the bit; 4、要有一定的刚性防止提钻时板材颤动,又要有一定弹性,当钻头下钻接触的瞬间立即变形,使钻头精确地对准被钻孔的位置,保证钻孔位置精确。 4. It is necessary to have certain rigidity to prevent the plate from vibrating when lifting the drill, and also to have certain elasticity. When the drill bit is in contact with the drill, it will immediately deform, so that the drill bit is accurately aligned with the position of the drilled hole, and the drilling position is accurate. 5、厚度与公差要求。不平整的表面将对钻孔造成影响。 5. Thickness and tolerance requirements. Uneven surfaces will affect drilling. |
| 上一页 什么是路基 |
| 下一页 沟盖板模具在生产时如何避免出现色差 |